Panasonic AW-HEA10KPJ Manuale di installazione e istruzioni per l'uso - Pagina 33
Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Fotocamera digitale Panasonic AW-HEA10KPJ. Panasonic AW-HEA10KPJ 40. Control assist cameras
Anche per Panasonic AW-HEA10KPJ: Manuale di istruzioni per l'uso (34 pagine)
Stampa la pagina
Troubleshooting
The following are normal and not indicative of any problem.
The subjects appear distorted
When the flash is fired during
shooting, only the top or bottom of
the screen becomes lighter
Power
Symptom
No power
Web screen
Symptom
Web screen cannot be accessed
• A subject that moved across in front of the camera quickly may appear slightly distorted because a MOS is used
for the unit's image sensor, but this is not indicative of any problem.
• With a MOS image sensor, the shooting timing differs slightly between the top left and bottom right of the screen.
This means that when the flash is fired, the bottom of the screen will become lighter in the field concerned and
the top will become lighter in the next field. This is normal and not indicative of any problem.
Cause and solution
• When the status display lamp is off, power is not being supplied or the unit is
turned off.
→ Correctly connect the AC adaptor and the power cord.
→ Press the power button on the unit.
• If you turn off the unit with the power button of the unit, the unit cannot be turned
on from the Web screen. Press the power button to turn on the unit.
• Is the LAN cable connected securely to the IP control LAN connector?
• Is the network cable for the PoE (IEEE802.af) compatible power supply device and
the unit connected properly?
• Power may not be supplied if the total power limit is exceeded on power supply
devices that allow connections to multiple PoE terminals.
→ Refer to the operating instructions for the PoE power supply device.
Cause and solution
• Check the system requirements of the Web screen.
• Is a LAN cable of category 5 or higher connected?
• If the <LINK/ACT> LED of the LAN connector for IP control is off, a connection
has not been correctly established to the LAN or the network of the connection
destination is not working properly.
→ Check the LAN cable for a contact failure, and check the wiring.
• Is the power on?
→ I f the unit's status display lamp is off or lit orange, the unit is not on.
• Has a valid IP address been set in the unit?
• After changing the unit's IP address, enter "http://New IP address/" in the address
bar of the Web browser.
• Has the wrong IP address been accessed?
→ Check the connections by following the steps below.
For Windows:
Using the Windows command prompt, execute > ping [IP address which has been set
in the camera]. A reply returned from the unit signifies that there are no problems in
operation.
If a reply is not received, try following operation:
1 Press the <INIT> button to initialize the unit's network settings.
2 Start the Web setup screen and then configure the network settings again.
For Mac:
Using the OS X terminal, execute > ping -c 10 [IP address which has been set in
the camera]. A reply returned from the unit signifies that there are no problems in
operation.
If a reply is not received, try following operation:
1 Press the <INIT> button to initialize the unit's network settings.
2 Start the Web setup screen and then configure the network settings again.
Reference pages
– – –
– – –
page 19
page 19
page 19
Reference pages
page 25
page 29
page 29
page 29
PDF page 24
PDF page 16
– – –
33