aQuatell Fleck 5600SXT Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Distributore d'acqua aQuatell Fleck 5600SXT. aQuatell Fleck 5600SXT 15.

resistance is met and then give the valve another 1/12th turn. Because the valve is o-ring sealed

to the tank, the valve does not need to be over-tightened. Over-tightening can cause the o-ring to

become deformed and this can cause immediate or future leaking.

Putting it all together - The Brine Tank

If you received a softener that is 32,000 grains or less, the brine well (4" diameter white tube)

will be attached to the side of the brine tank already. If you received a softener larger than

32,000 grains you will need to attach the brine well to the side of the brine tank as follows:

1. Remove the lid from the brine well (4" diameter white

tube)

2. Carefully remove the float assembly from the inside of

the brine well.

3. Looking from the top (down the brine well), identify the

hole in the side of the brine well

4. Looking at the side of the brine tank (usually black) you

will see two holes.

5. Working from the outside of the brine tank pass the

threaded end of the overflow bulkhead fitting pictured

left through the bottom hole in the brine tank and

through the hole in the side of the brine well. Secure the

fitting (and the brine well) by attaching and tightening

the nut from the inside of the brine well.

6. The brine well should now be secured to the side of the

brine tank.

7. Attach a drain line to the barbed end of the bulkhead

fitting and run this to a floor drain.

Page 5

Fleck 5600SXT U.S. V1.1