aQuatell Fleck 5600SXT Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Distributore d'acqua aQuatell Fleck 5600SXT. aQuatell Fleck 5600SXT 15.

Putting it all together - The Float Assembly

If you haven't done so already, remove the lid from the brine well and carefully remove the float

assembly. You can do this by holding the elbow with the grey plastic hex nut and slowly pulling

this upwards. The float assembly is delicate, so proceed carefully. Once it's removed it will look

like this:

The float assembly controls the flow of brine solution out of the brine tank, and the flow of fresh

water into the brine tank. On the thin vertical bar of the float assembly identify the two black

rubber washers. These washers control the range of motion of the cup-shaped float.

Ensure that the top washer is about 3" below the top standoff and about two inches above the

bottom standoff. When these rubber washers are positioned properly the float will hit the top

washer before the brine tank water level gets to the brine tank overflow (the same piece that

holds the brine well to the brine tank)

The next step is to unscrew the hex nut from the top of the float assembly (see orange arrow

above). Once the hex nut is removed you will see a small tube insert inside. Remove the tube

insert and keep it and the hex nut aside then carefully lower the float assembly back down into

the brine well.

Page 6

Fleck 5600SXT U.S. V1.1