aquatherm AT600 Manuale di installazione - Pagina 13

Sfoglia online o scarica il pdf Manuale di installazione per Pompa di calore aquatherm AT600. aquatherm AT600 16. Swimming pool & spa heat pumps
Anche per aquatherm AT600: Manuale operativo del proprietario (12 pagine), Manuale operativo del proprietario (12 pagine)

Stampa la pagina

Jandy™ & Compool™ Connections

for Compool

Attach the 2 wire cable to the Compool's power center board located on the

terminals labeled "HTR" *See the controllers installation guide also.

for AquaLink RS

cable to positions #1 and position # 2

on the 10 slot, green terminal bar inside

the AquaLink's power center. *See the

controllers installation guide also.

AQUASWITCH or JI2000

First, remove the black wire located in position # 2 on the black terminal bar and cap. Do not

remove any other factory wires that may share the same positions as the 3 wire cable.

NOTE: Other non

thermostat type of

controls hook up the

same way shown

here.

The control will uti-

lize the heaters t-

stats, the control will

switch between pool

and spa t-stat.

Leave the heater's

switch in pool mode.

Next, attach the 3 wire cable

to the HEATER on the black

terminal bar as follows:

#2 COMMON

#3 LOW/POOL

#4 HIGH/SPA

*See the controller's installation guide also.

Attach the 2 wire

12 11 10 9 8

Attach the other end of the 3 wire

cable to the JI2000 as follows:

#10 For the HIGH/SPA

#11 For the LOW/POOL

#12 For the COMMON

for "Prologic" Analog Control Models

7 6 5 4 3 2

Attach the other end of the 3

wire cable to the

AquaSwitch as follows:

#12 For the HIGH/SPA

#13 For the COMMON

#14 For the LOW/POOL

NOTE: The control

will have thermostat

control over heater.

Turn the heater's t-

stats all the way up

and leave the switch

in pool mode.

Page 13