DiamondBoxx PASUB15 Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Altoparlanti DiamondBoxx PASUB15. DiamondBoxx PASUB15 10.

The Amplifier Control Panel

AUDIO IN 1 - This is a 1/4 inch jack that supports TS mono or TRS stereo

input from a main speaker like DiamondBoxx XL2, L, L2 or other portable

speakers, or the output of a preamplifier/mixer/laptop

2. AUDIO IN 2 – These are stereo RCA input jacks, connect to aux out or

subwoofer out of main speakers like DiamondBoxx PA10 or PA15 or a

preamplifier/mixer/laptop/stereo receiver

3. AUX IN – This is a 3.5mm stereo input jack, connect to the output jack of a

DiamondBoxx M3, L3 or preamplifier/mixer/laptop, or other portable

speakers that need more bass

4. PHASE SWITCH - This switch is used to blend the subwoofer with your

other speakers. First adjust the Low Pass control #5 (see below) and then

with music playing listen carefully to the bass and upper bass sounds while

pressing the button. One setting will result in more bass output than the

other, this means the subwoofer is blending better with your main speaker

in this setting. Keep the switch in that setting. Note: If the speaker

placement changes relative to the main speaker, you will have to repeat

the process to find the best setting.

5. LOW PASS - This used to select the frequencies that the subwoofer will

reproduce. Generally, you do not want your main speaker and the

subwoofer trying to reproduce the same frequencies. Therefore, if your

main speaker has a frequency response down to 70Hz, you should set this

control somewhere between 60 – 80 Hz. The control is not linear, 80Hz is

the 12 o'clock or straight up position of the knob. Some recommendations

to use with our other products are listed below for good starting points.

After this is set, adjust Gain Knob #6 to a level that sounds like a good

blend with the main speaker. When the crossover and gain level is set

appropriately you shouldn't really notice that there is a Subwoofer... until

you shut the subwoofer off.

DiamondBoxx M3: turn bass to minimum on M3, set this knob to 80Hz

DiamondBoxx L, L2: set this knob to 70Hz

DiamondBoxx L3: keep bass knob at center 0 on L3, set this knob to 60Hz

DiamondBoxx XL, XL2: set to SPL mode, set this knob to 50-60Hz

DiamondBoxx PA10: bass knob at 12 to 3 o'clock, set this knob to 80Hz

DiamondBoxx PA10: bass knob at 12 to 3 o'clock, set this knob to 60Hz