DiamondBoxx PASUB15 매뉴얼 - 페이지 6
{카테고리_이름} DiamondBoxx PASUB15에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DiamondBoxx PASUB15 10 페이지.
The Amplifier Control Panel
1.
AUDIO IN 1 - This is a 1/4 inch jack that supports TS mono or TRS stereo
input from a main speaker like DiamondBoxx XL2, L, L2 or other portable
speakers, or the output of a preamplifier/mixer/laptop
2. AUDIO IN 2 – These are stereo RCA input jacks, connect to aux out or
subwoofer out of main speakers like DiamondBoxx PA10 or PA15 or a
preamplifier/mixer/laptop/stereo receiver
3. AUX IN – This is a 3.5mm stereo input jack, connect to the output jack of a
DiamondBoxx M3, L3 or preamplifier/mixer/laptop, or other portable
speakers that need more bass
4. PHASE SWITCH - This switch is used to blend the subwoofer with your
other speakers. First adjust the Low Pass control #5 (see below) and then
with music playing listen carefully to the bass and upper bass sounds while
pressing the button. One setting will result in more bass output than the
other, this means the subwoofer is blending better with your main speaker
in this setting. Keep the switch in that setting. Note: If the speaker
placement changes relative to the main speaker, you will have to repeat
the process to find the best setting.
5. LOW PASS - This used to select the frequencies that the subwoofer will
reproduce. Generally, you do not want your main speaker and the
subwoofer trying to reproduce the same frequencies. Therefore, if your
main speaker has a frequency response down to 70Hz, you should set this
control somewhere between 60 – 80 Hz. The control is not linear, 80Hz is
the 12 o'clock or straight up position of the knob. Some recommendations
to use with our other products are listed below for good starting points.
After this is set, adjust Gain Knob #6 to a level that sounds like a good
blend with the main speaker. When the crossover and gain level is set
appropriately you shouldn't really notice that there is a Subwoofer... until
you shut the subwoofer off.
DiamondBoxx M3: turn bass to minimum on M3, set this knob to 80Hz
DiamondBoxx L, L2: set this knob to 70Hz
DiamondBoxx L3: keep bass knob at center 0 on L3, set this knob to 60Hz
DiamondBoxx XL, XL2: set to SPL mode, set this knob to 50-60Hz
DiamondBoxx PA10: bass knob at 12 to 3 o'clock, set this knob to 80Hz
DiamondBoxx PA10: bass knob at 12 to 3 o'clock, set this knob to 60Hz