DiaTecne PulsePen WPP001-ETT Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature mediche DiaTecne PulsePen WPP001-ETT. DiaTecne PulsePen WPP001-ETT 16.

In order to install the Software contained in the included USB memory, proceed as described below

avoiding insertion of the wRS1 unit in the USB port before completion of operations.

1. In the "WPulsePen x_x_x Install" folder, launch Setup.exe to install the WPulsePen software and the

wRs1 receiver USB driver. A desktop icon will be automatically created.

2. Once the installation is finished, insert the wRs1 unit in the USB port and wait for the correct device

identification. In case of problems, manually reinstall the USB drivers from folder "wRs Usb Driver".

The font "Arial" is required for a correct use. Repeat the step 1 of the procedure if you wish to install also

the WPulsePen_LP software, selecting the "WPulsePen_LP x_x_x Install" folder.

Use of the device

Insert the wRS1 receiver in a USB port and wait for device recognition.

Extract the cap from the wEc1 and wTn1 units, insert batteries into the battery compartment strictly

following the indicated polarity (see pg 2) and close the cap.

⚠ Use only 1.5V IEC LR03 – AAA Alkaline batteries.

Note: dead batteries must be discarded in the special containers, since they are high-pollution wastes!

This device requires fresh disposable ECG electrodes Ag/AgCl

(incorporated with gel), that can be used for crocodile clips. Place

them as indicated in the figure:

Red: subclavian right region

Black: subcostal left region

The suggested position can be modified at the operator's

discretion when ECG signals are too low, inverted or altered, for

example in case of pathologies. Direct electrodes contact with

synthetic dresses must be avoided because it may cause

superimposed noises; in this case it helps to put one sheet of

paper in-between.

Connect the crocodiles of the patient cable to the corresponding

electrodes according to their types (type A or type B, see figure

on the right) and plug the cable from the other side into the

corresponding wEc1 sockets.

Run the Software WPulsePen / WPulsePen_LP and switch on the wEc1 / wTn1 units by pressing the on/off

key until the beep(s) sound (about 1 sec). wEc1 makes a single "beep", so does wTn1 when programmed as

Sensor1 (red trace), while wTn1 programmed as Sensor2 (blue trace) makes two "beeps".

1. New examination.

2. Patient Archive access.

3. Setup and device programming.

4. Online Help.

5. Data exchange between computer and wRs1 (green when in normal function).

6. wRs1 USB unit connection (green when correctly recognized)

7. Graphical battery gauge for wEc1 and wTn1.

! 5

User Manual PulsePen - V. 4.6