Alpha Marine Systems Alpha 3000 Manuale di installazione e funzionamento - Pagina 12
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Sistema autopilota Alpha Marine Systems Alpha 3000. Alpha Marine Systems Alpha 3000 16.
Stampa la pagina
12. Reinstall the clamp and install the drive link screw. Secure with Lock-Tite™
13. With the Morse Control engage the Drive Link with the
position. Swing
the helm slowly through the Autopilot operating range while observing the unit to ensure
sufficient clearance. The Drive Unit MUST NOT touch anything along its entire
length. This must be done slowly or damage to the Drive Unit may occur. See caution
note below. With the Drive Unit fully retracted, disengage latch and swing Helm hard
over to hard over and check clearance. With the Drive Unit fully extended disengage
latch and swing Helm hard over to hard over while checking for clearance.
14. Install the Morse control head at the chosen location per instructions included with it
and check
for proper latch motion.
15. Recheck that the Drive Unit centers the Helm. Minor adjustments may be made by
screwing the ram in or out up to one full turn. If further adjustment is necessary, the
rear mounting bracket must be moved.
16. Lubr icate the Driv e Unit Ba ll Joint with marin e grease as this is sh ipped d ry.
Proceed with the Compass installation section if all of the above tests are satisfactory.
The Drive Unit moves toward the rudder stock when the Helm is put hard over manually.
It MUST
be given clearance or great stress will be placed on the Drive Unit with possible damage
resulting.
DO NOT attempt to move the Drive Unit beyond its normal operating range
of +/- 9" (On SDU Drive Units +/- 6.0").
* * CAUTION * *
Autopilot in the OFF