Alpha Marine Systems Alpha 3000 설치 및 운영 매뉴얼 - 페이지 12

{카테고리_이름} Alpha Marine Systems Alpha 3000에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Marine Systems Alpha 3000 16 페이지.

12. Reinstall the clamp and install the drive link screw. Secure with Lock-Tite™

13. With the Morse Control engage the Drive Link with the

position. Swing

the helm slowly through the Autopilot operating range while observing the unit to ensure

sufficient clearance. The Drive Unit MUST NOT touch anything along its entire

length. This must be done slowly or damage to the Drive Unit may occur. See caution

note below. With the Drive Unit fully retracted, disengage latch and swing Helm hard

over to hard over and check clearance. With the Drive Unit fully extended disengage

latch and swing Helm hard over to hard over while checking for clearance.

14. Install the Morse control head at the chosen location per instructions included with it

and check

for proper latch motion.

15. Recheck that the Drive Unit centers the Helm. Minor adjustments may be made by

screwing the ram in or out up to one full turn. If further adjustment is necessary, the

rear mounting bracket must be moved.

16. Lubr icate the Driv e Unit Ba ll Joint with marin e grease as this is sh ipped d ry.

Proceed with the Compass installation section if all of the above tests are satisfactory.

The Drive Unit moves toward the rudder stock when the Helm is put hard over manually.

It MUST

be given clearance or great stress will be placed on the Drive Unit with possible damage

resulting.

DO NOT attempt to move the Drive Unit beyond its normal operating range

of +/- 9" (On SDU Drive Units +/- 6.0").

* * CAUTION * *

Autopilot in the OFF