Alpha Professional Tools AIR-680 Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Sander Alpha Professional Tools AIR-680. Alpha Professional Tools AIR-680 20. Pneumatic polisher
Anche per Alpha Professional Tools AIR-680: Manuale di istruzioni (20 pagine)

Stampa la pagina

When you remove the screw (658-91) without disconnecting the

air supply, compressed air will start leaking out and push the screw

while removing. When installing the oil port screw, install until the

O-ring and screw head make contact with the Endcase.

Warning: Over tightening of the oil port screw can strip the

screw and/or internal thread of the Endcase.

hoW To Add The RusT INhIbIToR oIl

1. Disconnect the tool from your air supply.

2. Remove the screw (Part No. 658-91) using

a #1 phillips head miniature screw driver.

(See Fig. 1)

3. Add 2 -3 drops of the rust inhibitor oil into

the oil port. (See Fig. 2)

4. Reinstall the screw (Part No. 658-91).

5. Reconnect the tool to your air supply.

6. Turn the valve lever (Part No. 658-50)

slightly so the air is leaking through the

tool. (Spindle of tool should not spin

during this process). (See Fig. 3)

7. Replacement Rust Inhibitor Oil can be

purchased from Alpha

(Part No. AIR-008).

Lubricating the tool before and during work is not needed. Excessive

oil will turn to a tar-like substance inside the tool, causing the vanes

to stick in the rotor and slow the tool down. This is the reason we do

not recommend automatic oilers be used with this tool. Old or worn

compressors, which emit oil through the air lines, can significantly

shorten the life of the tool.

WARNING!

Professional Tools