Alpha Professional Tools AIR-680 Manuale di istruzioni - Pagina 12

Sfoglia online o scarica il pdf Manuale di istruzioni per Sander Alpha Professional Tools AIR-680. Alpha Professional Tools AIR-680 20. Pneumatic polisher
Anche per Alpha Professional Tools AIR-680: Manuale di istruzioni (20 pagine)

Stampa la pagina

throttle only. Do not attempt to exceed the recommended speed by

excess pressure. This will significantly shorten the life of the tool.

When storing the tool overnight, disconnect from the air supply and

open the valve.

helPful hINT:

• Air valve lever should be opened and closed slowly to allow

the tool to accelerate and decelerate during all applications.

Rapid acceleration and deceleration can wear out the ball

bearings prematurely.

helPful hINT:

• Using a Filter Regulator System is

Recommended

fIlTeR/ReGulAToR sysTem

Having a Filter/Regulator helps prevent

pressure drops when using a large

volume of air, so you can set the

pressure to the tools at 85 PSI, while the main system can run at

125 PSI. The F/R unit will also remove any water from the air supply

while also filtering the air of contamination down to five microns. By

only using aluminum and brass after the F/R unit, you are eliminating

any rust and contamination from getting into the air tools.

The Alpha

F/R Manifold System comes in two sizes, 53 CFM & 106

CFM and three adapter blocks: 3/8", 1/2" and 3/4", and is designed

for installation at the point of use. All F/R manifolds are custom-

configured to a clients specific needs and are available through our

distributor network, and via our website.

WATeR CoNTRol VAlVe

This valve lets you adjust the flow of water

through the spindle. It may be used to shut

off the water entirely when changing discs.

When storing the tool overnight, open the

valve and drain all water from the supply

hose and tool.