DieHard 200.71465 Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Caricabatterie DieHard 200.71465. DieHard 200.71465 16. 60/20/2 amp fully automatic battery charger 275/125 amp engine starter with battery tester

Stampa la pagina

Make sure the POWER switch is set to the OFF

position.

Next plug the power cord into a

grounded AC outlet.

For automatic charging, touch AUTO then a

charge-rate pad. The charger will quit when the

battery is fully charged.

For manual charging touch a charge rate pad then

select a charge time, from up to 18 hours. If

more than 135 minutes of charging time is

needed, reset the time when the original time runs

out. Refer to the time chart in the "Setting the

Controls" on page 8 of "Using Your Battery

Charger."

In the MANUAL mode at the 60-Amp charging

rate, the METER will show a charge rate of 25 to

30 amps or less when the battery is at or near full

charge. At the 20-Amp charging rate, the METER

will show a charge rate of 8 to 10 amps or less

when the battery is at or near full charge. At the 2-

Amp charging rate, the METER will show a charge

rate of .75 to 1 amp when the battery is at or near

full charge.

10. TO AVOID OVERCHARGING in the Manual

Mode, monitor the METER frequently.

11. When the battery is fully charged, turn the

POWER switch to the OFF position and unplug

the charger power cord.

12. Standing away from the battery, remove the

charger leads. Remove the grounded clamp first,

then the one on the battery.

13. Clean and store the battery charger in a dry

location.