DieHard 200.71465 소유자 매뉴얼 - 페이지 12

{카테고리_이름} DieHard 200.71465에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DieHard 200.71465 16 페이지. 60/20/2 amp fully automatic battery charger 275/125 amp engine starter with battery tester

페이지 인쇄

Make sure the POWER switch is set to the OFF

position.

Next plug the power cord into a

grounded AC outlet.

For automatic charging, touch AUTO then a

charge-rate pad. The charger will quit when the

battery is fully charged.

For manual charging touch a charge rate pad then

select a charge time, from up to 18 hours. If

more than 135 minutes of charging time is

needed, reset the time when the original time runs

out. Refer to the time chart in the "Setting the

Controls" on page 8 of "Using Your Battery

Charger."

In the MANUAL mode at the 60-Amp charging

rate, the METER will show a charge rate of 25 to

30 amps or less when the battery is at or near full

charge. At the 20-Amp charging rate, the METER

will show a charge rate of 8 to 10 amps or less

when the battery is at or near full charge. At the 2-

Amp charging rate, the METER will show a charge

rate of .75 to 1 amp when the battery is at or near

full charge.

10. TO AVOID OVERCHARGING in the Manual

Mode, monitor the METER frequently.

11. When the battery is fully charged, turn the

POWER switch to the OFF position and unplug

the charger power cord.

12. Standing away from the battery, remove the

charger leads. Remove the grounded clamp first,

then the one on the battery.

13. Clean and store the battery charger in a dry

location.