Olympus BH2 Series Smontaggio, pulizia e rimontaggio - Pagina 11

Sfoglia online o scarica il pdf Smontaggio, pulizia e rimontaggio per Microscope Olympus BH2 Series. Olympus BH2 Series 45. Phase contrast
Anche per Olympus BH2 Series: Manuale di risoluzione dei problemi e regolazione (46 pagine), Smontaggio, pulizia e rimontaggio completi (23 pagine), Smontaggio, pulizia e rimontaggio completi (40 pagine), Manuale (6 pagine), Manuale di installazione (9 pagine)

Figure 10 – Secure mounting disk so the e-clip stays out

If, like most people, you do not have a spare mounting

disk from an old binocular head laying around, be

creative and improvise some other way to hold the

plunger in the depressed position so that you can access

and remove the e-clip from the plunger shaft (see

Figure

11, photo courtesy Joe Haralson).

Figure 11 – Where there's a will there's a way

Use a pair of needle-nosed pliers to carefully grasp and

remove the e-clip from the groove in the end of the

plunger shaft (see

Figure

Figure 12 – Carefully remove e-clip from the plunger shaft

Teardown, Cleaning, and Reassembly of the Miscellaneous Parts of the Olympus BH-2 Microscope Frames

12).

Remove the clamp holding the mounting disk in place,

and remove the mounting disk from the dovetail recess

of the viewing head, to allow the spring-loaded plunger

to re-extend within the mounting recess (see

Figure 13 – Remove mounting disk from dovetail recess

Grasp the exposed end of the plunger within the

mounting recess and withdraw the plunger rod from

the bore of the stationary inner barrel of the locking

screw (see

Figure

14).

Figure 14 – Remove plunger rod from the inner barrel

Use tweezers or some other suitable tool to remove the

extension spring from within the bore of the stationary

inner barrel of the locking screw (see

Figure 15 – Remove spring from stationary inner barrel

Figure

15).

Revision 1

Page 11 of 45

13).