Olympus BX43 Manuale di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per Microscope Olympus BX43. Olympus BX43 48. System microscope

Stampa la pagina

IMPORTANT

SAFETY PRECAUTIONS

Fig. 1

1. After the equipment has been used in an observation of a specimen that

is accompanied with a potential of infection, clean the parts coming in

contact with the specimen to prevent infection.

· Moving this product is accompanied with the risk of dropping the

specimen. Be sure to remove the specimen before moving this

product.

· In case the specimen is damaged by erroneous operation, promptly

take the infection prevention measures.

· Follow the procedures described in Chapter "Getting Ready" (see on

page 2) prior to using the accessories of this product. Otherwise, the

stability of the device will be lost and the dropped specimen will cause

the possibility of infection.

2. Install the microscope on a sturdy, level table or bench.

3. Be careful not to tilt the microscope too much. Otherwise, the mobile

parts such as the light path selector knob may move in unintended

directions.

4. Always use the power cord provided by Olympus. If no power cord is

provided, please select the proper power cord by referring to the section

"PROPER SELECTION OF THE POWER SUPPLY CORD" at the end of

this instruction manual.

If the proper power cord is not used, product safety performance cannot

be warranted.

5. Always ensure that the grounding terminal of the microscope and that of the

wall outlet are properly connected. If the equipment is not grounded, Olympus

can no longer warrant the electrical safety performance of the equipment.

Operation Using the LED Lamp

Safety Note on LED (Light Emitting Diode)

The LED incorporated in the LED lamp housing is a class 1 LED

product as defined in the applicable standard. The light emitted by LED

is basically safe, but do not look at the illumination light directly for an

extended period to prevent your eye from being injured

Operation Using the Halogen Bulb

1. To avoid potential shock hazards and burns when replacing the halogen

bulb, set the main switch of the TL4 power supply unit to "

allow the lamp socket @ and bulb to cool before touching them.

Designated bulb

Always use the designated lamp bulb. Using other bulb may

CAUTION

cause malfunction.

2. If the lamp cable or power cord comes in contact with the lamp socket

or its surroundings, the cable or cord may be melt by the heat, causing

an electric shock or fire hazard. To prevent this, distribute the lamp cable

and power cord at enough distances from the lamp socket.

3. The standard service life of the lamp housing is eight (8) years of use or

20,000 hours of total power ON period, whichever is the shorter period.

For details, see Inspection Sheet on page 38.

CLASS 1 LED PRODUCT

6V30WHAL (PHILIPS 5761)

BX43

(Fig. 1)

" (OFF) and