Axler CS-CPS-20a Manuale di avvio rapido - Pagina 3

Sfoglia online o scarica il pdf Manuale di avvio rapido per Camera Accessories Axler CS-CPS-20a. Axler CS-CPS-20a 6.

G E T T I N G S T A R T E D

Place the CS-CPS-20a Expanding Caterpillar Slider

on a steady surface. When used on its feet, e.g., on

the ground or a table, the CS-CPS-20a offers 18"

of sliding. You can adjust the length of the feet to

prevent the slider from wobbling and fine-tune the

position of the slider.

To extend the foot, rotate it clockwise. To retract

the foot, rotate it counterclockwise. (Fig. 1)

Tip: Use the onboard bubble level to determine

whether your shot is aligned with the horizon.

M O U N T I N G T H E S L I D E R

You can use a heavy-duty tripod or light stand to

support the slider and gain both height and tracking

length. When mounted, the CS-CPS-20a delivers

30" of sliding length. The slider's mounting base is

equipped with 1/4"-20 and 3/8"-16 sockets.

To mount the slider, follow these steps:

1. Center the mounting base on the slider, and lock it

down by tightening the brake. (Fig. 2)

2. Align your tripod's threaded post with the

corresponding mounting socket in the slider's

mounting base. Place the slider onto the threaded

post and carefully rotate the tripod until fully

attached. (Fig. 3)

3. Mount your camera to the slider according to the

directions below.

Note: To avoid wobbling and camera shake, use

sand bags or other weights to stabilize your tripod.