- ページ 3

カメラアクセサリー Axler CS-CPS-20aのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Axler CS-CPS-20a 6 ページ。

G E T T I N G S T A R T E D
Place the CS-CPS-20a Expanding Caterpillar Slider
on a steady surface. When used on its feet, e.g., on
the ground or a table, the CS-CPS-20a offers 18"
of sliding. You can adjust the length of the feet to
prevent the slider from wobbling and fine-tune the
position of the slider.
To extend the foot, rotate it clockwise. To retract
the foot, rotate it counterclockwise. (Fig. 1)
Tip: Use the onboard bubble level to determine
whether your shot is aligned with the horizon.
M O U N T I N G T H E S L I D E R
You can use a heavy-duty tripod or light stand to
support the slider and gain both height and tracking
length. When mounted, the CS-CPS-20a delivers
30" of sliding length. The slider's mounting base is
equipped with 1/4"-20 and 3/8"-16 sockets.
To mount the slider, follow these steps:
1. Center the mounting base on the slider, and lock it
down by tightening the brake. (Fig. 2)
2. Align your tripod's threaded post with the
corresponding mounting socket in the slider's
mounting base. Place the slider onto the threaded
post and carefully rotate the tripod until fully
attached. (Fig. 3)
3. Mount your camera to the slider according to the
directions below.
Note: To avoid wobbling and camera shake, use
sand bags or other weights to stabilize your tripod.