Accurate Technology Digi-Stop Manuale d'uso - Pagina 8
Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Accurate Technology Digi-Stop. Accurate Technology Digi-Stop 16. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws
Stampa la paginaChanging the Batteries
A low battery indicator will appear in the lower left corner of the LCD. When
battery voltage drops below approximately 2.6V the readout will turn itself off
until the batteries are replaced.
To replace the battery remove the screws in the upper right and lower left
corners. Pull the cover off. Remove the old batteries. Reinstall 2 new AA
Alkaline batteries, noting the proper orientation. Replace the cover and tighten
the screws.
CAUTION: DO NOT BEND THE BATTERY CLIPS!
THESE CLIPS ARE DESIGNED TO BE LOOSE WHEN THE CASE
IS OPEN AND WILL COMPRESS AND SECURE THE BATTERIES
IN PLACE WHEN THE CASE HALVES ARE SCREWED TOGETHER.
The LCD Display
The above figure illustrates all the segments available on the LCD.
(Not all segments are used on Digi-Stop Systems)
Pressing and holding the
/
and
key for 10 seconds with power off
ON
OFF
UNITS
will perform a full segment LCD test, display the current firmware version, and
RESET ALL PROGRAMMING PARAMETERS TO FACTORY DEFAULTS.
Manual Part # 800-1070-001, Rev G, 10-2008
Page 8 of 16