Accurate Technology Digi-Stop Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Strumenti di misura Accurate Technology Digi-Stop. Accurate Technology Digi-Stop 16. Complete digital stop and fence system for chop saws, radial arm saws, and miter saws
S
3
O
ECTION
PERATION
Readout Keys
Key Timing
The keys pictured above, are found on all Digi-Stop readouts, and some of
them have multiple functions.
Timing, which is how long a key is depressed, and the combination of the keys
pressed is important. This manual uses the term '"momentarily" to describe a
key press of shorter than 1 second. Whereas the term "press and hold" is used
to describe a key press of longer than 1.5 seconds. As an example; when using
a PC keyboard to type a capital letter you would "press and hold" the SHIFT
key and "momentarily depress the LETTER key. In addition most of the key
"functions" are executed on RELEASE, not press. This is important since
some of the same keys execute different functions based on how long they are
pressed and when they are released. These key operations, once tried will
quickly become intuitive.
On/Off
Momentarily pressing the
ON/OFF
key will cause the readout to turn on or off.
The Firmware Version of the readout is displayed on power-up when
ON/OFF
key is used. While the readout is on, if the stop is not moved for 15 minutes,
the readout will automatically turn itself off to conserve battery life. While it is
off if the stop is moved as little as .002in (.05mm), or the
ON/OFF
button is
pressed, the readout
will automatically turn itself back on with no loss of
position.
Units
The readout can display position information in decimal inches, fractions, or
millimeters. To change the current display mode, momentarily press the
UNITS
key.
With each key press the readout will cycle through decimal inches,
fractional inches and millimeters.
When the readout is in 1/16 or 1/32 inch fraction mode, a series of "bars" in the
upper right corner of the display, each representing 1/64th of an inch, may
appear. (ie. When in 1/16 inch mode and three bars are showing, the
measurement displayed is rounded down to the closest 1/16 inch and each
Accurate Technology DigiStop
Page 9 of 16