Epson 220 Manuale - Pagina 15

Sfoglia online o scarica il pdf Manuale per Stampante Epson 220. Epson 220 29. Epson printer parts manual

Removing the front push tractor

To remove the tractor from the front push position, follow

these steps:

1. Remove any paper from the tractor as described in the

previous section.

2. Turn off the printer.

3. Open the front paper guide by pulling the tab at the center

of the guide. Then remove the guide by grasping both sides

and pulling it straight out of the printer.

4. Press the tractor lock tabs, tilt the tractor up, and lift it out

of the printer.

5. Replace the front paper guide by sliding it along the printer

mounting slots until it locks in place. Then close the front

paper guide.

Using the Rear Push Tractor

To use the rear push tractor, load continuous paper in the rear

slot. For information on when to use the rear push tractor, see

"Available Paper Paths" on page 8.

Loading paper onto the rear push tractor

If a tractor is installed in the pull position, you need to remove

it and install the paper tension unit

Note:

To avoid paper jams, it is best to load thick multipart forms using the

front or bottom slot and pull or front push tractor.

Caution:

Do not load continuous paper with labels in the rear

paper slot; the labels may come off their backing sheet

inside the printer and cause a paper jam.

To load paper onto the rear push tractor, follow these steps:

1. Make sure the printer is turned off.

2. Open the paper guide cover and remove the paper guide.

paper guide

cover

3. Set the paper release lever to the rear push tractor position.

Then set the paper thickness lever to accommodate your

paper thickness.

2/99

EPSON LQ-2080

paper guide

EPSON LQ-2080

- 15