Axxess AXDSPL-HD1 Manuale di istruzioni per l'installazione - Pagina 3
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Elettronica per autoveicoli Axxess AXDSPL-HD1. Axxess AXDSPL-HD1 8. Harley davidson dsppackage with water resistant enclosure 1998-2013
Stampa la pagina
With the key in the off position:
1. Remove the fairing to access the back of the factory radio. Refer to MetraOnline,
part number 99-9600 for fairing disassembly instructions.
2. Install the AXDSPL-HD1 harness and make all necessary connections, but leave the amp
turn-on wire disconnected.
3. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from
the AXDSPL-HD1 harness into the left side of the cap. The locking clip on the connector
should face upward. Make sure the gasket is seating properly in the cap. (Figure A)
4. Withthearrowstampedontothecapstillfacingupwards,pushthe20-pinconnector from the
AXDSPL-HD1 harness into the right side of the cap. The locking clip on the connector
should face upward. Make sure the gasket is seating properly in the cap. (Figure A)
5. Plug the 16-pin and 20-pin connectors from the AXDSPL-HD1 harness into the
AXDSP-L circuit board. (Figure A)
6. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure
location in the fairing to secure it. Make sure the Axxess logo is facing up to further
ensure that no outside elements can enter the enclosure.
INSTALLATION
Continued on the next page
(Figure A)
Case
AXDSP-L
Circuit Board
Cap (with O-ring)
16-Pin
Gasket
AXDSPL-HD1
Harness
Zip-tie Mounts
20-Pin
REV. 8/4/2019 INSTAXDSPL-HD1
3