Axxess AXDSPL-HD1 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Axxess AXDSPL-HD1에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AXDSPL-HD1 8 페이지. Harley davidson dsppackage with water resistant enclosure 1998-2013

페이지 인쇄

With the key in the off position:

1. Remove the fairing to access the back of the factory radio. Refer to MetraOnline,

part number 99-9600 for fairing disassembly instructions.

2. Install the AXDSPL-HD1 harness and make all necessary connections, but leave the amp

turn-on wire disconnected.

3. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from

the AXDSPL-HD1 harness into the left side of the cap. The locking clip on the connector

should face upward. Make sure the gasket is seating properly in the cap. (Figure A)

4. Withthearrowstampedontothecapstillfacingupwards,pushthe20-pinconnector from the

AXDSPL-HD1 harness into the right side of the cap. The locking clip on the connector

should face upward. Make sure the gasket is seating properly in the cap. (Figure A)

5. Plug the 16-pin and 20-pin connectors from the AXDSPL-HD1 harness into the

AXDSP-L circuit board. (Figure A)

6. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure

location in the fairing to secure it. Make sure the Axxess logo is facing up to further

ensure that no outside elements can enter the enclosure.

INSTALLATION

Continued on the next page

(Figure A)

Case

AXDSP-L

Circuit Board

Cap (with O-ring)

16-Pin

Gasket

AXDSPL-HD1

Harness

Zip-tie Mounts

20-Pin

REV. 8/4/2019 INSTAXDSPL-HD1