Axxess AX-TYAMP1-SWC Manuale di istruzioni per l'installazione - Pagina 2
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Amplificatore Axxess AX-TYAMP1-SWC. Axxess AX-TYAMP1-SWC 8. Lexus/toyota amp interface with swc 2002-2015
Stampa la paginaFrom the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. This wire must be
connected to hear sound from the factory amplifier.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Tape off and disregard the following (5) wires, they will not be used in this
application: Blue/Pink, Brown, Green/Purple, Light Green and Orange/White.
AX-TYAMP1-SWC
Connections to be made
From the AX-TYAMP1-SWC harness to the aftermarket radio:
®
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the power antenna wire.
Attention! The AX-TYAMP1-SWC will work with both early and late generation
model Toyota SWC harnesses. Early generation models use a 20-pin harness; late
generation models use a 28-pin harness. Use only the appropriate harness that
the vehicle requires (only one of the harnesses will connect to the wiring harness
in the vehicle).
From the 20-pin harness:
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks
to the AUX input.
From the 28-pin harness:
• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks
to the AUX input.
The following (2) wires are for aftermarket multimedia/navigation radios that
require these wires. If not required, tape them off and disregard them.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
Continue to 3.5mm jack steering wheel control retention