- ページ 2

アンプ Axxess AX-TYAMP1-SWCのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Axxess AX-TYAMP1-SWC 8 ページ。 Lexus/toyota amp interface with swc 2002-2015

From the 16-pin harness with stripped leads to the aftermarket radio:

• Connect the Red wire to the accessory wire.

• Connect the Blue/White wire to the amp turn on wire. This wire must be

connected to hear sound from the factory amplifier.

• Connect the Gray wire to the right front positive speaker output.

• Connect the Gray/Black wire to the right front negative speaker output.

• Connect the White wire to the left front positive speaker output.

• Connect the White/Black wire to the left front negative speaker output.

• Connect the Green wire to the left rear positive speaker output.

• Connect the Green/Black wire to the left rear negative speaker output.

• Connect the Purple wire to the right rear positive speaker output.

• Connect the Purple/Black wire to the right rear negative speaker output.

• Tape off and disregard the following (5) wires, they will not be used in this

application: Blue/Pink, Brown, Green/Purple, Light Green and Orange/White.

AX-TYAMP1-SWC

Connections to be made

From the AX-TYAMP1-SWC harness to the aftermarket radio:

• Connect the Black wire to the ground wire.

• Connect the Yellow wire to the battery wire.

• Connect the Blue wire to the power antenna wire.

Attention! The AX-TYAMP1-SWC will work with both early and late generation

model Toyota SWC harnesses. Early generation models use a 20-pin harness; late

generation models use a 28-pin harness. Use only the appropriate harness that

the vehicle requires (only one of the harnesses will connect to the wiring harness

in the vehicle).

From the 20-pin harness:

• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks

to the AUX input.

From the 28-pin harness:

• If retaining the factory AUX-IN jack, connect the Red & White RCA jacks

to the AUX input.

The following (2) wires are for aftermarket multimedia/navigation radios that

require these wires. If not required, tape them off and disregard them.

• Connect the Green/Purple wire to the reverse wire.

• Connect the Light Green wire to the parking brake wire.

Continue to 3.5mm jack steering wheel control retention