CREE LIGHTING FLEX FLX24 Istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Apparecchiature di illuminazione CREE LIGHTING FLEX FLX24. CREE LIGHTING FLEX FLX24 4. Commercial specification troffers with emergency driver

Stampa la pagina

CREE LIGHTING FLEX FLX24 Istruzioni per l'installazione

TO INSTALL:

Luminaire Hooks

Cable Slots

T- BAR CEILING MOUNTING

STEP 1:

Bring the FLEX troffer up into the T-Bar grid.

STEP 2:

Locate the luminaire hooks and bend them out 90 degrees for

installation. See Figure 1.

NOTE: The luminaire hooks ship bent in and need to be bent out for

installation.

STEP 3:

Then bend the luminaire hooks against the T-Bar to secure the

luminaire. See Figure 1.

SUSPENDED MOUNTING

STEP 1:

Attach customer supplied cables to the (2) cable slots on each side of

the housing. See Figure 2.

STEP 2:

Attach customer supplied cables to mounting surface using customer

supplied hardware. Ensuring that mounting surface can support the

luminaire.

2 of 4

T-bar

1st:

90° Bend

2nd: Bend

Against T-bar

T-bar

Dimming Wire

Junction Box Cover

0 - 10V DIMMING OPTION

STEP 1:

Remove the cover of the junction box and bring in appropriate power

supply to the junction box using one of the knock-outs. See Figure 3.

STEP 2:

Remove the cover of the dimming junction box and bring dimming

conduit into dimming wire compartment using the knock-out. See

Figure 3.

STEP 3:

Wire luminaire per "Electrical Connections" section and push all leads

into the junction box. Reattach junction box cover that was removed in

Step 1 , make sure no wires are pinched.

STEP 4:

Install test switch assembly into ceiling by drilling a 1" hole into the

ceiling.

STEP 5:

Unscrew the small trim ring and place test switch assembly through the

ceiling. See Figure 4.

STEP 6:

Secure the test switch assembly by screwing the small trim ring

removed in Step 5 back onto the test switch assembly. Tighten the larger

trim ring above the ceiling until it is snugged tight against the ceiling.

See Figure 4 on the next page.

Power Supply

Junction Box Cover

LPN00439X0001A1_C