Creotech KLMKBM-01 Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Unità di controllo Creotech KLMKBM-01. Creotech KLMKBM-01 17. Ble mesh

Parameter

sensitivity

Frequency offset error

Co-channel interference

suppression

6 Module basic instructions

KLMKBM-01 module recommends that users can access the network through the

APP-"zhihui connect" developed by our company configuration.

Two bulbs are needed for control, and our module needs to be soldered to the

corresponding lamp board. If the bulb is pre-configured, you need to perform 5 short

power cycles (on/off every 2 seconds) to reset the bulb.

6.1 Add equipment



Click "Add Device" in the upper right corner to select the device you need

to add or enter the device name directly, such as RGBCW-BLE.



The initial device has entered the distribution network mode as soon as the

power is turned on, and then the lights start to flash; if it is a secondary

distribution network, follow the instructions of the distribution network

diagram, and then click the "start adding device" button.



Search the device, select the corresponding device to ad.



After the connection is complete, click "Finish" --device rename--choose

a family/room--connection succeeded;

Table 5.3 RX sensitivity

Min

Typical

1Mbps

-94.5

2Mbps

-91

1Mbps

-250

2Mbps

-300

-10

Max

Unit

dBm

+300

KHz

+200