Cisco 4500-M Manuale di installazione - Pagina 7

Sfoglia online o scarica il pdf Manuale di installazione per Interruttore Cisco 4500-M. Cisco 4500-M 18. Upgrading memory
Anche per Cisco 4500-M: Manuale di sostituzione (16 pagine), Manuale di aggiornamento (24 pagine)

Stampa la pagina

Step 5

Step 6

Mounting the Chassis in a Standard Rack

After removing the chassis shell and front panel, you can install the standard rack-mount brackets

into the chassis shell. The standard 19-inch rack-mount kit (see Figure 4) consists of two sets of one

bracket, one short extender (approximately five inches) (see Figure 5), and one long extender

(approximately ten inches) (see Figure 6).

If you have an older version of the chassis, use the ﬁrst of the following procedures to install the

standard rack-mount brackets. If you have a new version of the chassis, use the second procedure to

install the standard rack-mount brackets. After installing the brackets, use the third procedure to

install the chassis shell into a standard 19-inch rack.

Note

screw-mount chassis shells.

Figure 4

Rear of the chassis

While facing the rear panel of the chassis, pull the handle on the right side of the router

while you support the component tray with one hand. Slide the component tray out of the

chassis shell.

Set the component tray on your work surface.

The brackets provided with your kit ﬁt both the early, tab-mount chassis shells and the newer

Standard Rack-Mount Bracket and Extender

Long rear

bracket extender

Mounting the Chassis in a Standard Rack

Front of the chassis

Rack-mount

Cisco 4000 Series Rack-Mount and Wall-Mount Installation

bracket