Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota di installazione - Pagina 9

Sfoglia online o scarica il pdf Nota di installazione per Interruttore Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Anche per Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Nota di installazione (14 pagine), Manuale di soluzione (17 pagine), White Paper (19 pagine), Descrizione (1 pagine), Bollettino dei prodotti (6 pagine), Avviso (4 pagine), Scheda tecnica (9 pagine), Scheda tecnica (18 pagine), White Paper (18 pagine), Manuale di configurazione (8 pagine), Nota di installazione (28 pagine), Manuale di risoluzione dei problemi (11 pagine), Nota di installazione (18 pagine), Manuale d'uso (17 pagine), Nota di installazione (24 pagine), Manuale (19 pagine), Nota di installazione (36 pagine)

Stampa la pagina

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Nota di installazione

The MEM-XCEF720-1GB memory upgrade is required for the DFC3BXL upgrade only and is included

Note

as part of the DFC3BXL daughter card kit only.

These tools and supplies are required to remove and install the DFC3 daughter card:

•

Removing a CFC or DFC Daughter Card

If your Ethernet module has either a CFC or a DFC daughter card installed, you must remove the old

CFC or DFC daughter card before installing the new DFC daughter card. The folowing procedures are

provided:

•

An additional procedure for removing DFC3 daughter cards is provided for daughter cards installed on

Note

early versions of the WS-X6748-GE-TX Ethernet module that are equipped with stiffener brackets.

Removing the CFC Daughter Card

Warning

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

To remove a CFC daughter card, follow these steps:

Attach an ESD grounding strap to your wrist and to ground.

Step 1

If you are unsure about the correct way to attach an ESD grounding strap, refer to the

ESD Grounding Strap" section on page 42

Remove the Ethernet module from the Catalyst 6500 series switch.

Step 2

If you are unsure about the correct procedure for removing a module from the switch chassis, refer to

the

instructions.

Step 3

Place the Ethernet module on an antistatic mat with the front of the module facing toward you.

Use a Phillips-head screwdriver to remove the installation hardware, which consists of three securing

Step 4

screws and the two cap nuts. (See

78-15893-08

Antistatic mat or foam pad to support the removed module and an antistatic bag to store the removed

Central Forwarding Card (CFC) or DFC daughter card

Your own ESD-prevention equipment or the disposable grounding wrist strap included in the

upgrade kit

Number 1 Phillips-head screwdriver for the DFC daughter card installation hardware

Removing the CFC Daughter Card, page 9

Removing the DFC3 Daughter Card, page 11

"Removing and Installing Ethernet Modules in the Chassis" section on page 34

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

for instructions.

Figure

1.)

Removing a CFC or DFC Daughter Card

"Attaching Your

for removal