Accutone WT99 Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Cuffie Accutone WT99. Accutone WT99 10. Dect headset system for telephones with handset lifter

Stampa la pagina
WT99 WIRELESS TELEPHONE HEADSET
your true wireless handsfree office solution!
Installation
E. Using External Sensor for the Lifter
The internal sensor within the handset lifter is used to pick up the ring tone
of the telephone and transmit a signal to your headset so you know there's
a call coming in while you are away from your desk.
But if the ringer speaker of your
telephone isn't located below or
close to the lifter, you will need to
use the supplied external sensor.
J
K
TROUBLESHOOT WARNING!
If for any reasons outside of the ones mentioned above, you still do not
receive any beep tone from your headset when the telephone is ringing, ie.
telephone ring volume too low...etc. Hook up the external sensor as
described and try speaking into the sensor with louder than normal
speaking volume, if this still doesn't generate any beep tone, contact your
reseller or service center as the sensor may be malfunctioning.
9
external sensor
Flip over the handset lifter to
reveal its bottom-side.
Connect the external sensor
plug to the
(J)
External Sensor
Jack or
(K)
External Sensor
Extension Jack if required.
F. Removing and Replacing Battery
The rechargeable battery of the WT99 headset is a detachable design and
can be replaced. It is a specific design and user should only use the official
battery supplied by Accutone. All rechargeable battery has a life-span and
should be removed from the headset during extended period of non-
usage. Contact your reseller for replacement battery purchase details.
To remove or replace the battery, turn the headset on its back, and open
the battery compartment from front to back as illustrated above.
rechargeable
battery
[ inspiring people, inspiring change ]
Installation
Lift up the hatch, the battery is
connected to the headset via
one connected cable, with a
white connector.
Carefully remove the battery
from the compartment and
holding the connector not the
cable, gently disconnect it.
Do not attempt to open the
plastic wrap of the battery
as the chemical inside is harmful
to human body.
10