Accutone WT99 Manual - Page 6

Browse online or download pdf Manual for Headsets Accutone WT99. Accutone WT99 10 pages. Dect headset system for telephones with handset lifter

Print Page

WT99 WIRELESS TELEPHONE HEADSET

your true wireless handsfree office solution!

Installation

E. Using External Sensor for the Lifter

The internal sensor within the handset lifter is used to pick up the ring tone

of the telephone and transmit a signal to your headset so you know there's

a call coming in while you are away from your desk.

But if the ringer speaker of your

telephone isn't located below or

close to the lifter, you will need to

use the supplied external sensor.

TROUBLESHOOT WARNING!

If for any reasons outside of the ones mentioned above, you still do not

receive any beep tone from your headset when the telephone is ringing, ie.

telephone ring volume too low...etc. Hook up the external sensor as

described and try speaking into the sensor with louder than normal

speaking volume, if this still doesn't generate any beep tone, contact your

reseller or service center as the sensor may be malfunctioning.

external sensor

Flip over the handset lifter to

reveal its bottom-side.

Connect the external sensor

plug to the

(J)

External Sensor

Jack or

(K)

External Sensor

Extension Jack if required.

F. Removing and Replacing Battery

The rechargeable battery of the WT99 headset is a detachable design and

can be replaced. It is a specific design and user should only use the official

battery supplied by Accutone. All rechargeable battery has a life-span and

should be removed from the headset during extended period of non-

usage. Contact your reseller for replacement battery purchase details.

To remove or replace the battery, turn the headset on its back, and open

the battery compartment from front to back as illustrated above.

rechargeable

battery

[ inspiring people, inspiring change ]

Installation

Lift up the hatch, the battery is

connected to the headset via

one connected cable, with a

white connector.

Carefully remove the battery

from the compartment and

holding the connector not the

cable, gently disconnect it.

Do not attempt to open the

plastic wrap of the battery

as the chemical inside is harmful

to human body.