Siemens SIWAREX WL230 BB-S SA Manuale - Pagina 27

Sfoglia online o scarica il pdf Manuale per Apparecchiature industriali Siemens SIWAREX WL230 BB-S SA. Siemens SIWAREX WL230 BB-S SA 36. Base plate and elastomer bearing bb-s sa
Anche per Siemens SIWAREX WL230 BB-S SA: Manuale di istruzioni per l'uso (48 pagine), Manuale dell'apparecchiatura (50 pagine), Manuale di istruzioni per l'uso (44 pagine)

Service and maintenance

NOTICE

Damage to load cells and load foots, measurement errors

● Dirt must not be allowed to accumulate in the vicinity of a load cell.

● Do not subject cable glands and seals directly to the jet of a pressure washer.

● Do not clean the load cell and installed parts with aggressive cleaning agents. Aggressive

● Clean the area around the load foot with running water. The load foot is not protected

6.1

6.1.1

General information

The physical properties of most rubber products change under poor storage conditions or with

improper treatment. The following examples of changes, however, can make them unusable:

● Excessive hardening

● Softening

● Permanent deformation

● Peeling, cracking and/or other surface damage

Such changes may be caused by external influences, for example:

● Environmental factors (ozone, heat, light, humidity)

● Solvents

● Storage under stress

Properly stored and treated rubber products will remain unchanged in their properties for a

period of several years.

SB-S CA

Manual, 06/2019, A5E47600142-AA

cleaning agents can also cause corrosion on stainless steel parts if used improperly.

against ingress of water.