Siemens SIWAREX WL230 BB-S SA Podręcznik - Strona 27
Przeglądaj online lub pobierz pdf Podręcznik dla Urządzenia przemysłowe Siemens SIWAREX WL230 BB-S SA. Siemens SIWAREX WL230 BB-S SA 36 stron. Base plate and elastomer bearing bb-s sa
Również dla Siemens SIWAREX WL230 BB-S SA: Instrukcja obsługi (48 strony), Instrukcja obsługi sprzętu (50 strony), Instrukcja obsługi (44 strony)
Drukuj stronę
Service and maintenance
NOTICE
Damage to load cells and load foots, measurement errors
● Dirt must not be allowed to accumulate in the vicinity of a load cell.
● Do not subject cable glands and seals directly to the jet of a pressure washer.
● Do not clean the load cell and installed parts with aggressive cleaning agents. Aggressive
● Clean the area around the load foot with running water. The load foot is not protected
6.1
Care and maintenance of elastomer components
6.1.1
Environmental influences/storage
General information
The physical properties of most rubber products change under poor storage conditions or with
improper treatment. The following examples of changes, however, can make them unusable:
● Excessive hardening
● Softening
● Permanent deformation
● Peeling, cracking and/or other surface damage
Such changes may be caused by external influences, for example:
● Environmental factors (ozone, heat, light, humidity)
● Solvents
● Storage under stress
Properly stored and treated rubber products will remain unchanged in their properties for a
period of several years.
SB-S CA
Manual, 06/2019, A5E47600142-AA
cleaning agents can also cause corrosion on stainless steel parts if used improperly.
against ingress of water.
6
27