Cisco WS-G5487 Nota di installazione - Pagina 6
Sfoglia online o scarica il pdf Nota di installazione per Interruttore Cisco WS-G5487. Cisco WS-G5487 10. Gigabit interface converter module and small form-factor pluggable module
Anche per Cisco WS-G5487: Scheda tecnica (6 pagine), Manuale di installazione e specifiche (24 pagine)
Stampa la pagina
Removing a GBIC
Figure 2
Plug
Step 4
Warning
Warning
modules when no cable is connected. Avoid exposure and do not stare into open apertures.
Step 5
Removing a GBIC
If you are removing a defective GBIC, perform these steps.
Step 1
Step 2
Step 3
Warning
6 Gigabit Interface Converter Installation Note
Installing a GBIC
WS-X5403
3 PORT GIGABIT ETHERNE
T SWITCHIN G MODULE
Slide the GBIC through the flap covering the opening into the slot until you hear a click.
The click indicates the GBIC is locked into the slot.
Class 1 laser product
Invisible laser radiation may be emitted from the aperture ports of the single-mode fiber-optic
When you are ready to attach the network interface fiber-optic cable, remove the plug
from the GBIC and save the plug for future use.
Disconnect the network fiber cable from the GBIC SC connector.
Release the GBIC from the slot by simultaneously squeezing the two plastic tabs (one on
each side of the GBIC).
Slide the GBIC out of the Gigabit Ethernet module slot. A flap drops down to protect the
Gigabit Ethernet module connector.
Ultimate disposal of this product should be handled according to all national laws and regulations.