Cisco WS-G5487 설치 참고 사항 - 페이지 6
{카테고리_이름} Cisco WS-G5487에 대한 설치 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WS-G5487 10 페이지. Gigabit interface converter module and small form-factor pluggable module
Cisco WS-G5487에 대해서도 마찬가지입니다: 데이터시트 (6 페이지), 설치 및 사양 매뉴얼 (24 페이지)
페이지 인쇄
Removing a GBIC
Figure 2
Plug
Step 4
Warning
Warning
modules when no cable is connected. Avoid exposure and do not stare into open apertures.
Step 5
Removing a GBIC
If you are removing a defective GBIC, perform these steps.
Step 1
Step 2
Step 3
Warning
6 Gigabit Interface Converter Installation Note
Installing a GBIC
WS-X5403
3 PORT GIGABIT ETHERNE
T SWITCHIN G MODULE
Slide the GBIC through the flap covering the opening into the slot until you hear a click.
The click indicates the GBIC is locked into the slot.
Class 1 laser product
Invisible laser radiation may be emitted from the aperture ports of the single-mode fiber-optic
When you are ready to attach the network interface fiber-optic cable, remove the plug
from the GBIC and save the plug for future use.
Disconnect the network fiber cable from the GBIC SC connector.
Release the GBIC from the slot by simultaneously squeezing the two plastic tabs (one on
each side of the GBIC).
Slide the GBIC out of the Gigabit Ethernet module slot. A flap drops down to protect the
Gigabit Ethernet module connector.
Ultimate disposal of this product should be handled according to all national laws and regulations.