Cisco 1600 series Manuale di avvio rapido - Pagina 5

Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete Cisco 1600 series. Cisco 1600 series 12. Rdiag router analog ipsec
Anche per Cisco 1600 series: Manuale di avvio rapido (8 pagine), Installazione o sostituzione manuale (10 pagine), Manuale di installazione dell'hardware (14 pagine)

Install the Router (continued).

B. Install the WAN interface card.

Look for a WAN interface card in the slot on the right-rear of the router, just above the slot labeled FLASH PC

CARD. (There is no WAN interface card installed if there is a metal plate over the slot.) If the card is already

installed, connect the card to your WAN line according to the instructions that came with the card. To install a

card, follow the instructions below.

Note: You must provide a Phillips

screwdriver for this step.

Step 1

Turn the power OFF by putting

the power switch in the O position.

Step 2

Remove the thumbscrews that

hold the slot cover in place.

Step 3

Remove the metal plate that

covers the card slot.

Step 4

Hold the card by the edges and

line it up with the guide on the card slot.

Step 5

Insert the card into the slot and

push in until it is firmly seated in the

connector and the card front panel is flush

with the router rear panel.

Step 6

Use the Phillips screwdriver to

tighten the screws that are in the card.

Step 7

Connect the correct cable to the

card according the instructions that came

with the card.

Step 8

Turn the power ON by putting

the power switch in the | position.