- ページ 5

ネットワーク・ルーター Cisco 1600 seriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1600 series 12 ページ。 Rdiag router analog ipsec
Cisco 1600 series にも：クイック・スタート・マニュアル (8 ページ), マニュアルの取り付けまたは交換 (10 ページ), ハードウェア・インストール・マニュアル (14 ページ)

Install the Router (continued).

B. Install the WAN interface card.

Look for a WAN interface card in the slot on the right-rear of the router, just above the slot labeled FLASH PC

CARD. (There is no WAN interface card installed if there is a metal plate over the slot.) If the card is already

installed, connect the card to your WAN line according to the instructions that came with the card. To install a

card, follow the instructions below.

Note: You must provide a Phillips

screwdriver for this step.

Step 1

Turn the power OFF by putting

the power switch in the O position.

Step 2

Remove the thumbscrews that

hold the slot cover in place.

Step 3

Remove the metal plate that

covers the card slot.

Step 4

Hold the card by the edges and

line it up with the guide on the card slot.

Step 5

Insert the card into the slot and

push in until it is firmly seated in the

connector and the card front panel is flush

with the router rear panel.

Step 6

Use the Phillips screwdriver to

tighten the screws that are in the card.

Step 7

Connect the correct cable to the

card according the instructions that came

with the card.

Step 8

Turn the power ON by putting

the power switch in the | position.