Cisco 2612 Manuale di avvio rapido - Pagina 17

Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete Cisco 2612. Cisco 2612 29. Including license and warranty
Anche per Cisco 2612: Manuale di avvio rapido (29 pagine)

Stampa la pagina
Step 4
Secure the wires using cable ties.
Step 5
Turn on power to the DC circuit.

Connecting Routers to the Cisco Redundant Power System

If your router uses the Cisco Redundant Power System (RPS), refer to the Cisco RPS Hardware Installation Guide for
instructions about the power connections. To locate these documents, see the "Where to Go Next" section on page 24.

WAN, LAN, and Voice Connections

The connections and cables listed here are described in detail in the following documents:
• Cisco 2600 Series Hardware Installation Guide
• Cisco Network Modules Hardware Installation Guide
• Cisco Interface Cards Installation Guide
• Cisco Modular Access Router Cable Specifications
To locate these documents, see the "Where to Go Next" section on page 24.
Table 3 summarizes some typical WAN, LAN, and voice connections for Cisco 2600XM series and Cisco 2612 routers.
Table 3
WAN, LAN, and Voice Connections
Port or Connection
Port Type, Color
Ethernet
RJ-45, yellow
T1/E1 WAN
RJ-48C/CA81A, blue
Cisco serial
60-pin D-sub
Cisco Smart serial
Cisco Smart compact
connector, blue
DSL
RJ-11C/CA11A,
lavender
T1 digital voice
RJ-48C/CA81A, tan
Analog voice FXS
RJ-11, gray
Analog voice FXO
RJ-11, pink
Analog voice E&M
RJ-11, brown
BRI S/T WAN
RJ-48C/CA81A, orange NT1 device or private integrated
(external NT1)
BRI U WAN
RJ-49C/CA-A11, red
(built-in NT1)
CT1/PRI
T1
CT1/PRI-CSU
T1
CE1/PRI
E1
Token Ring
UTP, purple
STP, purple
56/64-kbps DSU/CSU 8-pin modular, blue
1. See the Cisco Modular Access Router Cable Specifications document for information about selecting these cables.
Connected To:
Ethernet hub or Ethernet switch
T1 or E1 network
CSU/DSU and serial network or
equipment
CSU/DSU and serial network or
equipment (For WIC-2T and
WIC-2A/S only)
Network demarcation device for
service provider's DSL interface
Digital PBX
Telephone, fax
Central office, analog PBX
Analog PBX
network exchange (PINX)
ISDN network
External T1 CSU
RJ-48C/CA81A interface
E1 network
Token Ring device
RJ-48S interface
Cable
Straight-through Ethernet
RJ-48 T1
Cisco serial transition cable that matches
the signaling protocol (EIA/TIA-232,
EIA/TIA-449, V.35, X.21, or EIA-530)
and the serial port operating mode (DTE
1
or DCE).
RJ-11
RJ-48 T1 cable
RJ-11
RJ-11
RJ-11
RJ-48
RJ-49
DB-15 T1 serial cable
RJ-48 straight-through
DB-15 to BNC, DB-15 to DB-15,
DB-15 to twinax, or DB-15 to RJ-45
RJ-45 Token Ring cable
RJ-48 straight-through
17