Cisco 2612 Skrócona instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Router sieciowy Cisco 2612. Cisco 2612 29 stron. Including license and warranty
Również dla Cisco 2612: Skrócona instrukcja obsługi (29 strony)

Drukuj stronę

Step 4

Secure the wires using cable ties.

Step 5

Turn on power to the DC circuit.

Connecting Routers to the Cisco Redundant Power System

If your router uses the Cisco Redundant Power System (RPS), refer to the Cisco RPS Hardware Installation Guide for

instructions about the power connections. To locate these documents, see the "Where to Go Next" section on page 24.

WAN, LAN, and Voice Connections

The connections and cables listed here are described in detail in the following documents:

• Cisco 2600 Series Hardware Installation Guide

• Cisco Network Modules Hardware Installation Guide

• Cisco Interface Cards Installation Guide

• Cisco Modular Access Router Cable Specifications

To locate these documents, see the "Where to Go Next" section on page 24.

Table 3 summarizes some typical WAN, LAN, and voice connections for Cisco 2600XM series and Cisco 2612 routers.

Table 3

WAN, LAN, and Voice Connections

Port or Connection

Port Type, Color

Ethernet

RJ-45, yellow

T1/E1 WAN

RJ-48C/CA81A, blue

Cisco serial

60-pin D-sub

Cisco Smart serial

Cisco Smart compact

connector, blue

DSL

RJ-11C/CA11A,

lavender

T1 digital voice

RJ-48C/CA81A, tan

Analog voice FXS

RJ-11, gray

Analog voice FXO

RJ-11, pink

Analog voice E&M

RJ-11, brown

BRI S/T WAN

RJ-48C/CA81A, orange NT1 device or private integrated

(external NT1)

BRI U WAN

RJ-49C/CA-A11, red

(built-in NT1)

CT1/PRI

CT1/PRI-CSU

CE1/PRI

Token Ring

UTP, purple

STP, purple

56/64-kbps DSU/CSU 8-pin modular, blue

1. See the Cisco Modular Access Router Cable Specifications document for information about selecting these cables.

Connected To:

Ethernet hub or Ethernet switch

T1 or E1 network

CSU/DSU and serial network or

equipment

CSU/DSU and serial network or

equipment (For WIC-2T and

WIC-2A/S only)

Network demarcation device for

service provider's DSL interface

Digital PBX

Telephone, fax

Central office, analog PBX

Analog PBX

network exchange (PINX)

ISDN network

External T1 CSU

RJ-48C/CA81A interface

E1 network

Token Ring device

RJ-48S interface

Cable

Straight-through Ethernet

RJ-48 T1

Cisco serial transition cable that matches

the signaling protocol (EIA/TIA-232,

EIA/TIA-449, V.35, X.21, or EIA-530)

and the serial port operating mode (DTE

or DCE).

RJ-11

RJ-48 T1 cable

RJ-11

RJ-48

RJ-49

DB-15 T1 serial cable

RJ-48 straight-through

DB-15 to BNC, DB-15 to DB-15,

DB-15 to twinax, or DB-15 to RJ-45

RJ-45 Token Ring cable

RJ-48 straight-through