Cisco 3640 Series Manuale di avvio rapido - Pagina 29
Sfoglia online o scarica il pdf Manuale di avvio rapido per Router di rete Cisco 3640 Series. Cisco 3640 Series 37. Rack-mount and wall-mount
Anche per Cisco 3640 Series: Manuale di installazione (10 pagine), Manuale d'uso (17 pagine), Manuale d'uso (26 pagine), Manuale (10 pagine), Nota di configurazione (18 pagine)
Stampa la pagina
Step 10 Respond to the following prompts as appropriate for your network:
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]: yes
Configure IP on this interface? [yes]:
IP address for this interface: 10.1.1.1
Subnet mask for this interface [255.0.0.0] : 255.255.0.0
Class A network is 10.0.0.0, 16 subnet bits; mask is /16
Step 11 After the following messages appear, press Return to save the basic configuration:
The following configuration command script was created:
hostname 3600
enable secret 5 $1$Ksjf$za4T2lb3ARS5d1PHVzW5A0
enable password xxxx
line vty 0 4
password xxxx
snmp-server community public
!
no ip routing
!
interface FastEthernet0/0
no shutdown
media-type 100BaseX
full-duplex
ip address 10.1.1.1 255.255.0.0
!
interface FastEthernet0/1
shutdown
no ip address
!
end
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
% You can enter the setup, by typing setup at IOS command prompt
Press RETURN to get started! RETURN
Step 12 The user prompt appears.
3600>
When you have completed the initial configuration tasks, your Cisco router is ready to configure for specific functions. See the
"Where to Go Next" section on page 32 for information about locating documentation for advanced configuration procedures.
29