Ca Go Lockable Cargo Box Lid Manuale di istruzioni per il montaggio - Pagina 16

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Accessori per biciclette Ca Go Lockable Cargo Box Lid. Ca Go Lockable Cargo Box Lid 20.

Stampa la pagina

Assembly

Fig. 3

First, the six fastening points marked in the Cargo Box Lid (Fig. 3) must be

drilled through with the aid of the enclosed tool (Fig. 4).

Two procedures are suitable for this purpose:

1. The tool can be clamped in a cordless screwdriver and used as a drill.

To do this, use the marks visible on the outside of the lid as a guide and

drill the holes from the outside to the inside. It is recommended that the

speed is as high as possible and the feed rate is as low as possible to

prevent the EPP from tearing out.

2. If you do not have a cordless screwdriver available, you can also pierce the

hole by hand. To do this, first screw in the enclosed tool 2-3 mm from the

outside at the marked points. Then pierce the holes from the inside by also

pushing the tool through the pilot holes with a rotating motion.

Fig. 4