Ca Go Lockable Cargo Box Lid 조립 지침 매뉴얼 - 페이지 16

{카테고리_이름} Ca Go Lockable Cargo Box Lid에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ca Go Lockable Cargo Box Lid 20 페이지.

Assembly

Fig. 3

First, the six fastening points marked in the Cargo Box Lid (Fig. 3) must be

drilled through with the aid of the enclosed tool (Fig. 4).

Two procedures are suitable for this purpose:

1. The tool can be clamped in a cordless screwdriver and used as a drill.

To do this, use the marks visible on the outside of the lid as a guide and

drill the holes from the outside to the inside. It is recommended that the

speed is as high as possible and the feed rate is as low as possible to

prevent the EPP from tearing out.

2. If you do not have a cordless screwdriver available, you can also pierce the

hole by hand. To do this, first screw in the enclosed tool 2-3 mm from the

outside at the marked points. Then pierce the holes from the inside by also

pushing the tool through the pilot holes with a rotating motion.

Fig. 4