Cisco ASA 5506-X Montare il telaio - Pagina 4

Sfoglia online o scarica il pdf Montare il telaio per Hardware di rete Cisco ASA 5506-X. Cisco ASA 5506-X 10. Threat defense reimage guide
Anche per Cisco ASA 5506-X: Manuale di avvio rapido (10 pagine), Manuale di avvio rapido (14 pagine), Manuale di configurazione facile (11 pagine), Manuale del software (37 pagine), Montare e collegare (12 pagine), Manuale di installazione (46 pagine), Manuale di installazione dell'hardware (26 pagine)

Rack-Mount the Chassis

Figure 2: Attach Cable Guides to Sliding-Rack Tray Flange

Two cable guides (part number 700-122664-01)

Right cable guide rack tray cutouts

a) Align the cable guides with the cutouts on the sliding-rack tray flange (see figure above).

b) At the rear of the sliding-rack tray, attach the left and right cable guides using the six Phillips M3 x 0.5 x 10 mm

screws (part number 48-0796-01).

Note

c) Set the sliding-rack tray aside. Continue with Step 2 to install the rack shelf on the chassis.

The figure in Step 8 shows the sliding rack tray with the cable guides attached.

Step 2

Place the chassis with the top facing down on a large, stable work area.

Step 3

Invert the rack shelf and position it on the chassis. You can mount the chassis with the front or rear panel facing front.

Mount the Chassis

Drive the screws in while facing the back of the sliding-rack tray.

Left cable guide rack tray cutouts

Six Phillips M3 x 0.5 x 10 mm screws (part number

48-0796-01)

Mount the Chassis