Cisco Catalyst 8300 Series Manuale di installazione dell'hardware - Pagina 39

Sfoglia online o scarica il pdf Manuale di installazione dell'hardware per Hardware di rete Cisco Catalyst 8300 Series. Cisco Catalyst 8300 Series 46. Edge ucpe

Stampa la pagina

Install and Upgrade Field Replaceable Units

2. Tighten the screw.

Figure 1. PIM slot

Installing Drive Bays

If you have not ordered drives, the drive bay slot is closed with a blank cover.

These are the steps to install a drive in a drive bay:

E1.S Modules

Note

1. Remove the filler in the E1.S slot

2. Press the latch-release button on the E1.S module so that the latch springs to the open position.

3. Slide the E1.S module in the slot and push forward until the module seats in the connector.

4. To secure the module in the chassis, close the latch until it catches the latch-release button.

Figure 1: Inserting the E1.S module in the slot

Securing screw

The drive bay is in the front panel of the device. The bay is closed with a cover if there are no drives in the

slots.

Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide

Installing Drive Bays

PIM Module