Cisco Catalyst 8300 Series 하드웨어 설치 매뉴얼 - 페이지 39

{카테고리_이름} Cisco Catalyst 8300 Series에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 8300 Series 46 페이지. Edge ucpe

Install and Upgrade Field Replaceable Units

2. Tighten the screw.

Figure 1. PIM slot

Installing Drive Bays

If you have not ordered drives, the drive bay slot is closed with a blank cover.

These are the steps to install a drive in a drive bay:

E1.S Modules

Note

1. Remove the filler in the E1.S slot

2. Press the latch-release button on the E1.S module so that the latch springs to the open position.

3. Slide the E1.S module in the slot and push forward until the module seats in the connector.

4. To secure the module in the chassis, close the latch until it catches the latch-release button.

Figure 1: Inserting the E1.S module in the slot

Securing screw

The drive bay is in the front panel of the device. The bay is closed with a cover if there are no drives in the

slots.

Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide

Installing Drive Bays

PIM Module