B.M.C. M2 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore B.M.C. M2. B.M.C. M2 8.

Stampa la pagina

Front Panel Functions

POWER
POWER
Turn to switch the unit ON and OFF
DIGM Display
Shows the selected DIGM Gain (00-66)
DIGM mode is only possible with an optical DIGM signal from a B.M.C.
Audio unit with DIGM Gain Control, such as the DAC1.
Attention: When this display goes out, the M2 is in Power Amplifier Mode
and gain is set to maximum, that means DIGM 66!
Maximum gain is intended for classical Pre-Amplifier / Power-Amplifier
use.
Never use the M2 in Power Amplifier Mode with a fixed level output
source!
POWER Meter
Shows actual power in WATT (at 4 Ohm)
Level indicator in dB, reference level 0 dB equals 1 W
INPUT Indicator
Shows the selected INPUT
Attention: The XLR-CI can only be selected, if an active optical DIGM
signal is present!
INPUT Selector
Turn for changing INPUT.
Attention: The XLR-CI can only be selected, if an active optical DIGM
signal is present!
4
Remote Control
INPUT
The M2 does not come with a remote control
and it does not have a remote control
receiver. MUTE and VOLUME can be
controlled via an external B.M.C. Audio
+
mute
DIGM control unit, such as the DAC1, if an
IN
VOL
optical fiber connection between the two is
AMP
-
established.
disp
rep.
NOT FOR M2!
prog
check
clear
When using the shown remote control RC-1
and trying to change VOLUME or MUTE,
1
2
3
please apply the DAC section, not the AMP
section.
4
5
6
Pointing the remote control RC1 at the M2
does not work, so please point at the DAC1
(or some other B.M.C. Audio unit intended
7
8
9
for controlling DIGM).
0
CD
+10
df
ovs
ups
VOLUME Up
DAC
+
IN
VOL
VOLUME Down
-
mute
MUTE
Mutes the signal. (Displayed on the DAC1)
Unmute by pressing MUTE again. Changing
the volume will not unmute the signal, that
RC-1
can only be done by pressing MUTE again!
13