B.M.C. M2 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz B.M.C. M2. B.M.C. M2 8 stron.

Drukuj stronę

Front Panel Functions

POWER
POWER
Turn to switch the unit ON and OFF
DIGM Display
Shows the selected DIGM Gain (00-66)
DIGM mode is only possible with an optical DIGM signal from a B.M.C.
Audio unit with DIGM Gain Control, such as the DAC1.
Attention: When this display goes out, the M2 is in Power Amplifier Mode
and gain is set to maximum, that means DIGM 66!
Maximum gain is intended for classical Pre-Amplifier / Power-Amplifier
use.
Never use the M2 in Power Amplifier Mode with a fixed level output
source!
POWER Meter
Shows actual power in WATT (at 4 Ohm)
Level indicator in dB, reference level 0 dB equals 1 W
INPUT Indicator
Shows the selected INPUT
Attention: The XLR-CI can only be selected, if an active optical DIGM
signal is present!
INPUT Selector
Turn for changing INPUT.
Attention: The XLR-CI can only be selected, if an active optical DIGM
signal is present!
4
Remote Control
INPUT
The M2 does not come with a remote control
and it does not have a remote control
receiver. MUTE and VOLUME can be
controlled via an external B.M.C. Audio
+
mute
DIGM control unit, such as the DAC1, if an
IN
VOL
optical fiber connection between the two is
AMP
-
established.
disp
rep.
NOT FOR M2!
prog
check
clear
When using the shown remote control RC-1
and trying to change VOLUME or MUTE,
1
2
3
please apply the DAC section, not the AMP
section.
4
5
6
Pointing the remote control RC1 at the M2
does not work, so please point at the DAC1
(or some other B.M.C. Audio unit intended
7
8
9
for controlling DIGM).
0
CD
+10
df
ovs
ups
VOLUME Up
DAC
+
IN
VOL
VOLUME Down
-
mute
MUTE
Mutes the signal. (Displayed on the DAC1)
Unmute by pressing MUTE again. Changing
the volume will not unmute the signal, that
RC-1
can only be done by pressing MUTE again!
13