Cisco SCE 1000 and Manuale di avvio rapido - Pagina 45
Sfoglia online o scarica il pdf Manuale di avvio rapido per Hardware di rete Cisco SCE 1000 and. Cisco SCE 1000 and 49. Service control engine 1000 2xgbe
Stampa la pagina
• Troubleshooting the management subsystem:
show interface Mng — Displays IP address and auto-negotiation information for the management interfaces. Following
–
is a sample output from the show interface Mng command.
Following is a sample output from the show interface Mng command.
ip address: 10.1.6.145
subnet mask: 255.255.0.0
Configured speed: auto, configured duplex: auto
AutoNegotiation is On, link is Up, actual speed: 100, actual duplex: half
show ip default-gateway — Displays the IP address of the configured default gateway.
–
Following is a sample output from the show ip default-gateway command.
Default gateway: 10.1.1.1
show ip route — Displays the entire routing table and the destination of last resort (default-gateway).
–
Following is a sample output from the show ip route command.
gateway of last resort is 10.1.1.1
show access-lists — Shows all access-lists or a specific access list.
–
Following is a sample output from the show access-lists command.
Standard IP access list 1
Permit 10.1.1.0, wildcard bits 0.0.0.255
deny any
show telnet — Displays the status of the telnet server daemon (status) or any active Telnet sessions (sessions).
–
Following is a sample output from the show telnet command.
show telnet sessions
There is 1 active telnet session:
Index | Source
================
0
| 10.1.1.201
show telnet status
Telnet deamon is enabled.
show line vty timeout — Shows the timeout configured for Telnet sessions.
–
Following is a sample output from the show line vty timeout command.
Timeout is 30 minutes
45