Cisco SCE 1000 and Manual de início rápido - Página 45
Procurar online ou descarregar pdf Manual de início rápido para Hardware de rede Cisco SCE 1000 and. Cisco SCE 1000 and 49 páginas. Service control engine 1000 2xgbe
Imprimir página
• Troubleshooting the management subsystem:
show interface Mng — Displays IP address and auto-negotiation information for the management interfaces. Following
–
is a sample output from the show interface Mng command.
Following is a sample output from the show interface Mng command.
ip address: 10.1.6.145
subnet mask: 255.255.0.0
Configured speed: auto, configured duplex: auto
AutoNegotiation is On, link is Up, actual speed: 100, actual duplex: half
show ip default-gateway — Displays the IP address of the configured default gateway.
–
Following is a sample output from the show ip default-gateway command.
Default gateway: 10.1.1.1
show ip route — Displays the entire routing table and the destination of last resort (default-gateway).
–
Following is a sample output from the show ip route command.
gateway of last resort is 10.1.1.1
show access-lists — Shows all access-lists or a specific access list.
–
Following is a sample output from the show access-lists command.
Standard IP access list 1
Permit 10.1.1.0, wildcard bits 0.0.0.255
deny any
show telnet — Displays the status of the telnet server daemon (status) or any active Telnet sessions (sessions).
–
Following is a sample output from the show telnet command.
show telnet sessions
There is 1 active telnet session:
Index | Source
================
0
| 10.1.1.201
show telnet status
Telnet deamon is enabled.
show line vty timeout — Shows the timeout configured for Telnet sessions.
–
Following is a sample output from the show line vty timeout command.
Timeout is 30 minutes
45