Cisco SG 100D-08 Manuale di avvio rapido - Pagina 4
Sfoglia online o scarica il pdf Manuale di avvio rapido per Hardware di rete Cisco SG 100D-08. Cisco SG 100D-08 13. Unmanaged gigabit switch with qos
Anche per Cisco SG 100D-08: Manuale di avvio rapido (8 pagine), Manuale di avvio rapido (13 pagine)
Stampa la pagina
Rack-Mount Placement
Follow these steps to rack-mount the switch in any standard 19-inch rack.
Place the switch on a hard, flat surface with the front panel facing
S
1
TEP
towards you.
Attach a rack–mount bracket to one side of the switch with the
S
2
TEP
supplied screws and secure the bracket tightly. Repeat this step to
attach the other bracket to the opposite side of the switch.
After the brackets are attached to the switch, use suitable screws
S
3
TEP
to securely attach the brackets to any standard 19-inch rack.
Wall Mounting
A Cisco SF 100-16, SF 100-24, SG 100-16, or SG 102-24 Unmanaged
Rackmount Switch can be wall-mounted.
Before you begin, you need 2 wallboard screws (included) to mount the
unmanaged rackmount switch. We recommend using screws with a
minimum of 4mm width at the head and a shaft diameter of at least 1.5mm.
Insecure mounting might damage the device or cause injury.
W
ARNING
Cisco is not responsible for damages incurred by insecure wall-
mounting.
To mount the unmanaged rackmount switch to the wall:
Determine where you want to mount the unmanaged rackmount
S
1
TEP
switch. Verify that the surface is smooth, flat, dry, and sturdy.
Drill two pilot holes into the surface 3.74 inches (95 mm) apart, and
S
2
TEP
with a minimum of 5. 1 2 inches (130 mm) of clearance.
3
Cisco Unmanaged Rackmount Switches