Cisco SG 100D-08 Краткое руководство по эксплуатации - Страница 4

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сетевое оборудование Cisco SG 100D-08. Cisco SG 100D-08 13 страниц. Unmanaged gigabit switch with qos
Также для Cisco SG 100D-08: Краткое руководство по эксплуатации (8 страниц), Краткое руководство по эксплуатации (13 страниц)

Rack-Mount Placement

Follow these steps to rack-mount the switch in any standard 19-inch rack.

Place the switch on a hard, flat surface with the front panel facing

TEP

towards you.

Attach a rack–mount bracket to one side of the switch with the

TEP

supplied screws and secure the bracket tightly. Repeat this step to

attach the other bracket to the opposite side of the switch.

After the brackets are attached to the switch, use suitable screws

TEP

to securely attach the brackets to any standard 19-inch rack.

A Cisco SF 100-16, SF 100-24, SG 100-16, or SG 102-24 Unmanaged

Rackmount Switch can be wall-mounted.

Before you begin, you need 2 wallboard screws (included) to mount the

unmanaged rackmount switch. We recommend using screws with a

minimum of 4mm width at the head and a shaft diameter of at least 1.5mm.

Insecure mounting might damage the device or cause injury.

ARNING

Cisco is not responsible for damages incurred by insecure wall-

mounting.

To mount the unmanaged rackmount switch to the wall:

Determine where you want to mount the unmanaged rackmount

TEP

switch. Verify that the surface is smooth, flat, dry, and sturdy.

Drill two pilot holes into the surface 3.74 inches (95 mm) apart, and

TEP

with a minimum of 5. 1 2 inches (130 mm) of clearance.

Cisco Unmanaged Rackmount Switches